Latest News

Usually this is due to a poor sub-floor like those found in many older homes. Some older flooring reacts to the humidity changes by expanding and contracting, sometimes causing cupping or crowning effect on the strips. When you walk on the floor the pieces might flatten out and cause a rubbing effect that gives a

Re-sanding a floor: When we re-sand (or refinish) a wood floor, we bring in large sanding machines that strip all of the old finish and stain off the floor, exposing a layer of new wood. This new layer can then be stained (if desired) and finished with anywhere from 2 to 5 coats, depending on

In spite of all their advantages, modern wood floor finishes will not last forever. Hardwood floors should be recoated when the original finish shows signs of wear, but before it has worn through the finish to the bare wood. Bare wood can be stained by dirt and grime, resulting in the need for re-sanding. Many

Measure each room, multiplying length by width. You will need to buy extra material to compensate for waste when boards are trimmed or when damaged material must be cut from a board. Waste is much less with the better grades of wood. Usually, you will need 10% to 12% extra. Laying the floor diagonally or

Yes. You can expect to see shade differences in your floor over time. The cause is usually from exposure to the ultra-violet rays of the sun, whether direct or indirect. This color change will be more noticeable in lighter colors, which will darken over time. In addition, certain species, like Brazilian Cherry, will naturally darken

This is a very common question with a very simple answer. To ensure your floor stays in place and has a long life free of damaged caused my extreme contraction and expansion, maintain the humidity in your house at a level between 45% and 55%. This is a simple and efficient step to increase the

Nail Down or Staple Down – Typically used with the 3/4″ solid products. Solid Strip floors or Plank floors can only be installed on wooden sub-floors or sleepers on or above grade. 1″ to 2″ inch staples or nailing cleats are used to attach the wood flooring to the sub-floor. A pneumatic gun is used

The amount of preparation necessary depends on the condition of your current floor, and the type of flooring you decide to use. With our professional floor preparation, engineered wood and laminate flooring can be installed on almost any surface, even concrete. Solid wood flooring requires a sound wooden sub-floor in order to hold the staples